![]() I actually rewired mine so it would water lawn in proper physical order. OpenSprinkler is an open-source, web-based sprinkler timer / irrigation controller. If you opt to change your IP address away from 192.168.8.184, you should take note of your new. Opensprinkler programs only water in order of the stations 01-08 and cannot have a program that does stations in order 03,06,01,04 for example. Your router has two IP addresses, with more on that below. Its IP address is missing from Home Assistants console. Select whether you would like to have Remote Management open to all Internet IP Addresses, an Internet IP Address range or a single Internet IP Address. The good thing about having ISY integration and programs turning on the stations is I can water in different order now. I finally took the time to integrate openSprinkler into homeassistant, for now it only shows. I fixed by renaming the station in open sprinkler without the / and then I had to remove/add the poly for ISY to see. I think I have seen this before in other node servers but I would suggest to replace the / with whitespace or some other character depending on what the actual reason is. Other thing is I named one of my stations "Front Lawn/Side Lawn" and ISY does not show this station with the "/" slash character. ![]() I have worked around this by putting a wait of 5 seconds between each station on command in ISY program. kandi ratings - Low support, No Bugs, No Vulnerabilities. The web interface is on port 8080 of your Raspberry Pis IP address. If I turn on multiple stations too quickly in a program, instead of the open sprinkler queueing them, it seems to have more than one of the stations enabled on simultaneously - sometimes I have seen a couple, other times I have seen four on at once, which is not possible to do normally and it should normally queue them to run after each prior one is finished. Implement OSBeeWiFi-Firmware with how-to, Q&A, fixes, code snippets. OpenSprinkler Pi (OSPi) is a sprinkler / irrigation extension board for Raspberry. Since it is winter here up in Canada and cannot actually test it by watering the lawn, I can only test using the web UI response and seems to be working. ![]() So far it has worked fine as standalone but was surprised to see it in the store here! I happen to have an OpenSprinkler I purchased a couple years ago when my EZ-Flora died. I have just updated my OpenSprinkler Pi to the most recent version, using the 'git pull' method, and am now running version 2.2.2 () which can be seen in the bottom right-hand corner of the login and main screens.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |